Burns
Types of Burns
Thermal: flames, steam and/or hot liquids.
Electrical: damaged/faulty electrical cable, power points or lightning.
Chemical: acids, caustic soda etc.
Friction: any friction generating heat e.g. rope or carpet.
Radiation: sun, industrial equipment.
Serious Burns
Assessing Burns
There are two methods used to determine the severity of a burn:
Both of these methods need to be considered in conjunction to accurately calculate the extent of the injury.
Total Body Surface Area of Burns
You can estimate the total body surface area on an adult that has been burned by using multiples of nine (see chart below).
For an adult who has been burnt, the percentage of the body involved can be calculated as follows:
Head = 9%
Chest (front) = 9%
Abdomen (front) = 9%
Upper/mid/lower back and buttocks = 18%
Each arm = 9%
Each palm = 1%
Groin = 1%
Each leg = 18% total (front = 9%, back = 9%)
Depth of Burns
- Reddening of the skin e.g. light sunburn.
- Damage to the outer layer of skin only.
- Blistering.
- Weeping of clear fluid (plasma).
- Damage to the outer layer of skin only.
- White or blackened/charred areas.
- Damage to all layers of the skin, including underlying structures, tissue, muscle and bone.
Superficial Burns
A common cause of superficial burns is sunburn, with only the outside layers of the skin being affected.
If sunburn, remove casualty from direct sunlight into a cool shady environment.
Cool the burnt area with gently running, clean, cool water for a minimum of 20 minutes.
Hold the injured area close to the stream of water to avoid further pain.
Give casualty sips of cool water to hydrate.
Monitor for shock in young children. If signs of shock do appear, treat and seek medical assistance.
Partial Thickness Burns
The affected skin is red and blistering
.
There may be clear fluid (plasma) weeping from the burn.
Severe pain.
Cool the burnt area with gently running, clean, cool water for a minimum of 20 minutes. Water is always the first choice to cool a burn; if water is not available hydrogel products may be used.
Hold the injured area close to the stream of water to avoid further pain.
Carefully remove any clothing that is wet with hot liquid. Be aware of injury to yourself and take special care removing clothing over a casualty’s head to avoid injuring face and eyes.
Immediately remove any tight clothing, watch, rings or jewellery from the injured area because of the risk of swelling.
If possible elevate limb to reduce swelling.
Cover with a loose sterile non-stick dressing or kitchen wrap.
Minimise shock by placing casualty in the shock position.
Monitor the casualty.
Seek medical assistance.
Full Thickness Burns
If the casualty is on fire, drop them to the ground, if available cover with a fire blanket starting at the head, and roll the casualty on the ground to extinguish any flames. If a blanket is not available and water is, use water. Move away from the burn source.
Cool the burnt area with gently running, clean, cool water for a minimum of 20 minutes.
Hold the injured area close to the stream of water to avoid further pain.
Immediately remove any tight clothing, watch, rings or jewellery from the injured area because of the risk of swelling.
Cover with a loose sterile non-stick dressing or kitchen wrap.
If possible elevate limb to reduce swelling.
Continue running cool water over the dressing if pain persists.
Monitor the casualty’s vital signs; pulse, breathing and level of consciousness.
Reassure the casualty.
Call 000 for an ambulance.
DO NOT remove clothing that is stuck to the skin.
DO NOT pull burning, smoldering clothing over a casualty’s head.
DO NOT over-cool the casualty. If the casualty shivers or gets goose bumps, the body naturally starts to produce heat and we do not want this to happen!
DO NOT break any blisters.
DO NOT use cotton wool or any adhesive tapes/plasters.
DO NOT under-estimate burns, especially when the airway is involved.
DO NOT apply lotions, oils or butter (only use water soluble burn creams).
DO NOT use ice or ice water to cool the burn as further tissue damage may result.
Cold Burn
A cold burn is an injury to the skin caused by exposure to extreme cold or by touching a very cold surface. It may also be due to exposure to gas i.e. oxygen or L.P.G.
Treat as per burn management listed above.
Use warm water to try and bring the cold burn back up to normal skin temperature (ensure water is only warm NOT hot).
Chemical Burn
A chemical burn is an injury to the skin caused, usually, by alkali (e.g. ammonia, caustic potash, lime, sodium hydroxide) or acid (e.g. hydrochloric, sulphuric).
Be careful not to become contaminated yourself, avoid contact with any chemical or contaminated material e.g. use gloves.
Within the workplace, if available, refer to Material Safety Data Sheets (MSDS) for specific treatment.
Refer to instructions on the container for specific treatment.
If safe to do so, take the poison container to the telephone. Alternatively, if the poison container is contaminated, note down the product name and any ingredients listed. Take this note with you to the telephone.
Call the Poisons Information Centre of 13 11 26 for further advice.
Remove the chemical and any contaminated clothing immediately, taking care to avoid contact with the poison.
Brush powdered chemicals from the skin.
IMMEDIATELY run cool tap water directly onto the area for at least 20 minutes.
If chemical enters the eye, open and flush the affected eye(s) thoroughly with water for at least 20 minutes.
Seek medical assistance urgently.